Panduit PAT1M, Operation Manual

PAT1M / PAT1.5M OPERATION MANUAL 

PAT1M/PAT1.5M: PA22222A01_03 

Page: 22 of 36   

Dec., 2007

Problem 1 - No exit sensor seen - service tool soon 

No exit sensor seen - service tool soon

MENU

Buzzer

POSSIBLE CAUSE:

  This message is displayed if there is a cable tie in the feeder hose at the time the tool is 

actuated (at the start of the cycle), or, if the dispenser exit sensor is not functioning properly. 
 

CORRECTIVE ACTION:

  If this message appears, operation can be resumed immediately.  If operation is resumed 

and the same message is displayed, the dispenser exit sensor may be dirty, or it may not be functioning properly. 
 

PREVENTION:

  If this same error is repeated, the dispenser exit sensor lens may be cleaned with a cotton swab 

dampened with isopropyl alcohol.  Disconnect the feeder hose from the dispenser and insert the dampened end of 
the cotton swab into the dispenser strap tube about 1.5" (38 mm) and gently move the cotton swab in and out, 
against the top and bottom walls of the strap tube.  If the same error is repeated again, notify your maintenance 
department. 

Problem 2 - Switch #X is stuck or broken

Switch #X is stuck or broken

POSSIBLE CAUSE:

  This message will appear if a switch (button #1, 2, 3, 4, or the trigger) is held down or stuck 

when the dispenser is turned "on".  This message will also appear if one of these five switches has malfunctioned.  
The specific switch (button) that was held down or that has malfunctioned will be displayed at the beginning of the 
message. 
 

CORRECTIVE ACTION:

  When this occurs, the message will disappear when the switch (button #1, 2, 3, 4, or the 

trigger) has been freed or released.  If the "Switch #X is stuck or broken” message does not disappear, then the 
specific switch (button #1, 2, 3, 4, or the trigger) is bad.  Contact your maintenance department to have the switch 
replaced. 
 

PREVENTION: 

 To prevent this problem from recurring, do not press or hold down any switches (button #1, 2, 3, 4, 

or the trigger) when turning the dispenser power “on”. 

Problem 3 - Restore past tool count

Restore past tool count?

 Mem Off

Yes

No

POSSIBLE CAUSE:

  This message may appear if the tool counter is no longer functioning. 

CORRECTIVE ACTION:

  Press the 

"Yes"

 button and resume operation. 

PREVENTION: 

 If the same error is repeated, press the 

"Mem off"

 button and resume operation.  Notify your 

maintenance department. 

Downloaded from 

Elcodis.com

electronic components distributor