PAT1M / PAT1.5M OPERATION MANUAL
PAT1M/PAT1.5M: PA22222A01_03
Page: 4 of 36
Dec., 2007
DO NOT OPERATE IN WET OR DAMP AREAS:
DO NOT
operate the product in wet or damp areas. Operation of any electrical equipment in such an environment
constitutes a definite safety hazard.
KEEP AWAY FROM LIVE CIRCUITS:
•
Operating personnel must not remove covers.
•
Replacement of components and internal adjustments must be made by qualified
maintenance personnel.
•
Disconnect power cable when replacing components.
•
Dangerous voltages may exist even with the power cable removed.
•
To avoid injuries, always disconnect power and discharge circuits by grounding before
touching circuitry.
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT:
Because of the danger of introducing additional hazards, do not install substitute parts or perform an unauthorized
modification to the equipment. The proper components for service and repair may be obtained from Panduit
Corporation, Tool Division. The product may also be returned to Panduit Corporation, Tool Division for service and
repair to ensure that safety features are maintained (Subject to the provisions of the
PANDUIT
service agreement).
OPERATIONAL SAFETY PRACTICES
1. Safety glasses must be worn at all times by all persons within ten (10) feet of any part of the system.
2.
DO NOT
insert fingers in between the jaws of the tool or the rotary receiver area of the dispenser.
3.
DO
NOT
operate the tool with cover open or safety mechanism disabled.
4.
DO NOT
operate the tool with the rear jaw held open. Cable ties may be ejected from the tool at high velocities.
5.
DO NOT
operate the tool near anyone's face.
6.
DO NOT
operate the tool without a wire bundle in the jaws.
7.
DO NOT
operate the tool with any object blocking the path of the cable tie around the jaws.
The information contained in this manual is based on our experience to date and is believed to be
reliable. It is intended as a guide for use by persons having technical skill at their own discretion
and risk. We do not guarantee favorable results or assume any liability in connection with its use.
Dimensions contained herein are for reference purposes only. For specific dimensional
requirements consult the factory. This publication is not to be taken as a license to operate under,
or a recommendation to infringe any existing patents.
electronic components distributor
