© Panduit Corp. 2018
OPERATION MANUAL
PES400
ENGLISH
PES400: PA28981A01_01
Page: 45 of 46
4-2018
X & Y AXIS GUIDES & CLAMP
•
The X & Y Guides vital to the consistent
operation of the machine.
•
Clean the
Red
highlighted rails; then
spread a film of grease across the travel
paths.
•
After applying grease to the X & Y
Guides, also apply grease to the back of
the clamp.
FEEDER PUSHERS X2
•
Cleaning should be done by removing the two
securing plates in blue (use a 3mm Allen key)
from the left, and right sides of the feeder.
•
Wipe down the sides of the pusher rods, and
then spread a thin film of oil.
•
Inspect the teeth along the bottom & oil if
needed.
•
After, re-insert the pushers and make sure they
are placed in parallel laterally in the machine.
CHARACTERS & STRIKERS
•
Characters should be oiled every 10K
plates or weekly, whichever comes first.
•
Character removal is not required unless
an excessive amount of debris is visible.
A simple wipe down is usually sufficient.
•
The Strikers should be greased where the
strikers extend out of the punching
chassis.
