5. If using roll labels (or tags), load the roll onto the
Label Supply Spindle
so that
the printing side of the labels faces upwards as it unwinds from the roll. Push
the roll all the way to the inside of the printer and push the
Label Roll
Retainer
snugly against the outside of the label roll.
6. If using fanfold labels set them on a flat surface behind the printer. Pass the
labels (printing side up) through the slot in the rear of the printer.
7. Make sure the labels are routed
under the
Label Guide
and
through the
Sensor Assembly
.
8. Open the
Label Hold-Down
by
squeezing the green tab and the
release tab together. The
Label
Hold Down
is spring loaded and
will open automatically when the
latch is disengaged. Feed the labels
under the
Label Guide
, under the
Label Hold Down
, through the
Sensor Assembly
and out the front
of the printer.
9. Inspect the label routing and verify that the path matches that illustrated in the
Label Loading diagram. Set the
Adjustable Label Guide
to keep the labels
against the inside of the printer.
10. Close the
Label Hold-Down
by pushing downward on the green tab until it
latches closed.
12
Section 2. Installation
