SMARTZONE UPS USER MANUAL
15
UPS Physical Features and Accessories
The following sections provide an overview of the human and electrical interfaces on the
UPS unit. All UPS units are rack mountable with a display on the front side of the unit.
Physical Features
UPS Front Panel
The UPS Front Panel for all 1-3kVA Models are the same. Air flow vents occupy ¾ of
the front panel and a display module occupies the left ¼ of the front panel. The front
panel display module contains four status LEDs, a 2.8-inch segmented color display
and four function buttons.
Figure 3: 1-3kVA Font Panel
Air Flow Vents
The air flow vents are critical to the operation of the UPS unit. These vents must remain
clean and clear of all objects that may restrict the air flow through the UPS unit.
Status LEDs
Each unit has four Status LEDs, Normal LED (green), Battery LED (yellow), Bypass
LED (blue), and Alert LED (red/yellow). These LEDs provide a quick high-level view of
the unit’s operating conditions. Refer to
Color Display
The unit has a 2.8-inch segment color display. This display is used for monitoring,
control, and configuration. The display may be manually rotated to the orientation of the
unit. Remove the UPS faceplate, rotate the screen ¼ turn and then reinstall the UPS
faceplate.
Function Buttons
The UPS has four function buttons, the UP button, the DOWN button, the CANCEL/OFF
button, and the ENTER/ON/MUTE button. These buttons are used to navigate the
Monitor and the Setup screens, used to change settings, used to turn ON/OFF the UPS