PVIQ™ CONNECTIVITY SYSTEM USER MANUAL V 1.0
157
Performing a Maintenance Mode Reset
With the panel in Maintenance Mode
1.
Press and hold both Function Keys on the PM Interface Unit.
Result: The panel will move through each level of the resets at approximately 5
second intervals. At the end of the initial 5 seconds, the panel will produce a
Level 1 reset indication. The unit will beep once a second, and the outer most
port LED will change from Red to Green.
If you continue to hold the Function Keys down for another 5 seconds, a Level 2
reset will be indicated. The unit will beep two times per second, and the two
outermost port LEDs will change from Red to Green (see figure below).
Figure 118: Level 2 Reset Indication
2.
When the desired reset level is reached, release both Function Keys
simultaneously.
Result: The elected reset level indications will continue for approximately 5
additional seconds, during which the user can confirm or cancel the selected
reset.
To
confirm
: press and release the left Confirm Function Key and a beep will
follow. After the confirmation, reset level indications will turn off and the system
will perform the requested reset.
To
cancel
: press and release the right Cancel Function Key or let the panel
simply time out after 5 seconds (the time out will be acknowledged by three short
beeps).
Exiting Maintenance Mode
When the requested reset is complete, the panel will automatically exit the Maintenance
Mode, and will return to the state it was in before the Maintenance Mode was initiated
(Exception: If the panel was in Trace Mode, it returns to Secure Mode after a reset).
