INTELLIGENT GATEWAY INSTALLATION MANUAL
3
About This Guide
This document provides guidelines and instructions for installing and configuring the
SynapSense Intelligent Gateway device. The intended audience for this document
consists of customers or partners of SynapSense Corporation or a SynapSense installer
(or installation team). Customers, partners, or installers should receive training from
SynapSense prior to installing the hardware detailed in this document.
Industry Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Organization
Although we prefer the entire document to be read in order of presentation, we realize
that readers may jump to a particular section. The table below describes the chapters
and summarizes their content.
Table 1
–
Chapter Summary
Chapter
Description
Introduction
Provides an overview of the device, its capabilities, and minimum
requirements for use.
Installation & Configuration
Provides detailed steps for installing and configuring the device.
Installation Inspection
Provides the steps to verify proper installation and device
connectivity.
Troubleshooting
Provides information about correcting problems that may occur
during installation, configuration, or use of the device.
Document Conventions
The table below defines the style conventions used throughout this document.
