Page: 2 of 2
OPERATING INSTRUCTIONS
FIGURE 4:
5. Keeping the handles closed,
turn the tool over above a
waste wire receptacle or
other
scrap
container.
Holding the Rear Handle,
release the Trigger Handle.
All scrap cut wires should
drop free from the tool.
FIGURE 5:
6. Place the Wire Cap into the
required Jack Module.
7. Place the Wire Cap / Jack
Module assembly into the
Jack Seating side of the TGJT
Tool (opposite the Wire
Seating/Cutting side).
NOTE: IF WIRES DO NOT EJECT, MAKE SURE WIRE
RETAINERS COME IN CONTACT WITH THE BLADE
ANVILS DURING THE NEXT EMPTY HAND CYCLE. IF
NOT, THEY MAY NEED TO BE BENT SLIGHTLY INWARD.
FIGURE 7:
9. Pull the handle completely
closed until it stops. The Cam
Block Housing Ram will seat
the Wire Cap into the Jack
Module
completing
the
termination process. An
audible “snap” should be
heard during the seating
process.
10. Holding the Rear Handle,
release the Trigger Handle.
Pull the completed TG Jack
Module Assembly from the
tool.
NOTE: USING THE INCORRECT SETTING OF THE CAM BLOCK
HOUSING RAM CAN RESULT IN EITHER:
1.) A NON-FULLY SEATED WIRE CAP IN THE JACK
MODULE, OR
2.) DAMAGE TO THE TOOL IN THE JACK SEATING AREA OR
DAMAGE TO THE SHUTTER OF THE JACK MODULE IN
SHUTTERED JACKS
FIGURE 8:
11. Inspect the Jack Module
Assembly to make sure the
Wire Cap was fully seated
into the Jack Module. The
Retaining Finger should
have dropped into place
behind the Wire Cap ramp.
NOTE: JACK MODULE RETAINING FINGER MUST BE
ORIENTED TO ALIGN WITH RAMP AND POCKET OF
WIRE CAP.
RAMP
RETAINING FINGER
FIGURE 6:
8. Prior
to
the
handle
operation, the Cam Block
Housing Ram must be
rotated to match the type of
Jack Module being used.
For all standard jack modules
being used, the Cam Block
Housing Ram oval opening
must be rotated to horizontal
(parallel with the backbone of
the tool).
If
an
older
CJD-series
shuttered jack module is being
used (does not indlude the
newer CJH-series shuttered),
the Cam Block Housing Ram
oval opening must be rotated
to vertical.
REPLACEMENT KITS AVAILABLE
(Sold Separately)
KTGJTGRD – Protector Plate Kit
KTGJTBNA – Blade/Anvil Replacement Kit
KTGJTBLD – Blade Replacement Kit
HORIZONTAL – STANDARD
VERTICAL – CJD SERIES SHUTTERED
RAMP
SNAP!
RETAINING FINGER DOWN
© Panduit Corp. 2016
TGJT
