BA_PH_245-10_EN_13-22.docx
10
3.1
Intended Use
The PANHANS 245|10 tilting spindle moulder is used exclusively for machining materials for which the milling
cutter used is suitable (e.g. wood, chipboard, veneer). The machines are not suitable for milling metal resp. plas-
tic and waste wood which could contain nails, screws and other metal parts. The machine may only be operated
on a firm, level surface with a minimum load-bearing capacity of 1,000 kg/m.
Improper use can lead to danger to persons and to a defect or damage to the machine.
3.2
Target Group and Previous Experience
This operating manual is intended for the operating and maintenance personnel of the machine. The operating
personnel is to be determined by the operator and must further meet the following requirements:
•
Basic technical knowledge (e.g. apprenticeship as carpenter, machine fitter, etc. and/or practice in operat-
ing tilting spindle moulders resp. woodworking machines)
•
Reading and understanding these operating and maintenance instructions
In order to acquire the knowledge required to operate this machine, the operator must ensure the following
measures:
•
Product training for every operator (also possible external personnel)
•
Regular safety instruction
3.3
Requirements for the Operators
•
The tilting spindle moulder may only be operated by trained personnel who have also read this manual.
•
Inspection, maintenance, cleaning and repair may only be performed by technical specialists
with product-specific training and mechanical and/or electrical training.
•
Specialists with product-specific training are to be commissioned and held responsible for
planning and checking the work.
•
The national protective regulations for employees must be observed.
•
The operator is responsible for the safe use of the machine.
•
The legal minimum age must be observed.
