BA_PH_3V_EN_07-22.docx
13
4
General
This Bandsaw machine was produced by HOKUBEMA Maschinenbau GmbH according to the current state of the
art and placed on the market as a complete machine. All legal and normative regulations were observed.
4.1
Structure of the Machine
•
The 3-wheel bandsaw machine has a maximum cutting height of 1000 mm and a maximum cutting width
of 1450 mm.
•
The band saw blade speed is 1550 m/min.
•
The lower bandsaw wheel is driven by a three-phase motor and transmits the rotary motion to the blade.
The bandsaw wheels are provided with a wear- and tear-resistant coating that ensures a long service life.
•
The upper bandsaw wheel can be adjusted via a handwheel. This allows the machine to be optimally ad-
justed to the bandsaw blade.
•
To guide the workpieces, a table fence is provided, which is mounted to the left of the saw blade.
•
As protection against the saw blade and flying chips, the upper bandsaw guide is equipped with a guard.
•
The control panel is used to start the bandsaw and to release the motor brake.
•
The height adjustment of the upper saw blade guide including saw blade guard is motorised via a separate
control panel with two-hand control.
•
Both control panels have their own emergency stop switch.
•
The main switch is located on the rear of the machine.
4.2
Target Group and Previous Experience
This operating manual is intended for the operating and maintenance personnel of the machine. The operating
personnel is to be determined by the operator and must further meet the following requirements:
•
Basic technical knowledge (e.g. apprenticeship as carpenter, machine fitter, etc. and/or practice in operat-
ing woodworking machines)
•
Reading and understanding these operating and maintenance instructions
In order to acquire the knowledge required to operate this machine, the operator must ensure the following
measures:
•
Product training for every operator (also possible external personnel)
•
Regular safety instruction
4.3
Requirements for the Operators
•
The bandsaw machine may only be operated by trained personnel who have also read this manual.
•
Inspection, maintenance, cleaning and repair may only be performed by technical specialists
with product-specific training and mechanical and/or electrical training.
•
Specialists with product-specific training are to be commissioned and held responsible for
planning and checking the work.
•
The national protective regulations for employees must be observed .
•
The operator is responsible for the safe use of the machine.
•
The legal minimum age must be observed.
