BA_PH_680-200_EN_11-22.docx
69
20.2
Fault Messages on the Touchscreen
The touchscreen control reports various malfunctions in different ways:
1.
General Malfunctions and Warnings:
The screen frame of the control remains black and a pop-up window appears with the error message
.
2.
Safety-relevant Malfunctions and Warnings:
The screen frame of the control flashes alternately red / yellow and a pop-up window appears with the
respective error message
.
In the event of such an error, the safety chain is interrupted
→
All sawing units
and positioning processes are stopped and locked. In order to continue working on the machine, the mal-
function must first be remedied.
The following table shows the possible error messages, as well as their cause and remedy:
Figure 95: Error message 1
Message:
Rip fence folded down!
Cause:
•
Positioning of the rip fence is not possible as it is
folded down.
•
Toggle switch S13 jammed.
Remedy:
•
Move rip fence back into working position.
•
Check toggle switch S13 and loosen resp. remedy jam.
Figure 96: Error message 2
Message:
Rear cover is open!
Cause:
The rear cover of the machine stand is still open or not
properly closed.
Remedy:
Close rear cover.
Figure 97: Error message 3
Message:
Positioning error!
Cause:
•
Lag error when positioning the rip fence.
•
The rip fence is jammed.
•
Spindle guide of the rip fence too sluggish.
Remedy:
•
Remove blockade.
•
Clean spindle guide.
•
Ensure smooth running.
Figure 98: Error message 4
Message:
Slide table limit switch!
Cause:
Slide table has moved all the way to the back.
Remedy:
Move the slide table into working position.