BA_PH_690-200_EN_11-22.docx
78
22
Maintenance and Inspection
Before any maintenance and inspection work is carried out, chapter
observed!
Operational malfunctions caused by insufficient or improper maintenance can result in very high repair costs
and long machine downtimes. Regular maintenance is therefore essential.
Due to the different operating conditions, it is not possible to determine in advance how often a wear check,
inspection or maintenance is required. Inspection intervals are to be determined appropriately according to the
respective operating conditions.
•
Clean the machine daily.
•
Check all sliding or rolling parts weekly for smooth running and lubricate with a thin-bodied
oil if necessary.
•
Remove and replace damaged parts. Never work with damaged parts!!
•
Damaged guards, saw blades, clamping flanges, clamping nuts and riving knives must be replaced
immediately. Never work with damaged parts!
•
Clean the guideways of the sliding table monthly.
•
Inspect electrical equipment/components weekly for externally visible damage and have them
repaired by a qualified electrician if necessary.
•
Check the extraction unit for full function daily before starting work.
•
The extraction unit must be checked for obvious defects before initial commissioning, daily and
monthly to ensure its effectiveness.
•
The air velocity to the extraction system must be checked before the initial commissioning and
after significant modification.
•
Our specialists are at your disposal with further advice.
•
Do not use the machine until these conditions are met.
22.1
Lubrication Guide
Figure 109: Lubrication points on the height adjustment and rip fence spindle
•
Check all sliding or rolling parts weekly for smooth running and, if necessary, lubricate with a thin-
bodied oil.
•
Apply a few drops of oil to the threads of clamping and adjustment levers weekly.
•
Lightly grease the support bolt of the cross slide every month between the bolt and the cross slide.
•
Lubricate the two lubrication points (
S
) on the height adjustment of the sawing unit with 2 shots of
grease every month.
•
The three lubrication points (
S
) on the rip fence spindle are also lubricated monthly with 2 grease
shots.
S
S
S
S
S
