BA_PH_245-100-300_EN_06-22.docx
46
Fence plate adjustment
Loosen the star grip (
8
) and push the fence plate (
1
) to the desired position. Then retighten the star grip (
8
). Al-
ways adjust the plates so that they cover as much of the tool as possible without touching it.
Folding up the protective hood
Before the protective cover (
12
) of the fence can be folded up, the
locking bolt (
V
) at the rear left must be unlocked by pressing it in
(see
Fit a grooved board or safety rulers
To insert a grooved board or safety rulers, remove the splinter tabs
(
7
), attach the grooved board or safety rulers as fence bridges and
fasten them via the free threaded holes.
Figure 38: Locking bolt of Type 320
Tool covers for high milling arbors
By opening the knurled screws (
10
), the two cover plates can be moved, which is particularly advantageous with
high milling arbours. The opening should always be closed as far as possible without touching the milling arbor
or the cutter.
Lifting off and removing the fence
Increased risk of accidents due to the high weight of the fence! Lifting and placing the fence
should be done by at least two people or with a suitable hoist (e.g. an indoor crane)!
•
Danger of crushing hands and fingers between fence and machine table!
•
Wear protective gloves when lifting or placing the fence.
•
Acute risk of injury to the feet from the fence falling down!
•
Wear safety shoes with steel toecaps.
•
Press button on the touchscreen to release the electromechanical
clamping of the fence.
•
Fold up the two cover plates (
A
) on the left and right side of the
fence (see
•
Ten remove the two clamping screws (
S
) shown in
(unscrew them completely).
•
Then the fence can be swivelled away.
Due to the heavy weight of the fence, this operation should be carried
out by 2 persons or with a suitable hoist.
Figure 39: Clamping screws
Lifting off with Swivel-away Device (Option)
•
Press the button to release the electromechanical clamp.
•
Fold up the two cover plates (
A
) on the left and right side of the fence (see
•
Then remove the two clamping screws (
S
) shown in
Figure 39 (unscrew them completely).
•
Then the fence can be swivelled away.
•
When using a swivel-away device, follow the instructions on the touchscreen of the control unit.
For further information see section
16.3. The detailed procedure is described in the separately enclosed op-
erating manual
BA_PH_UT300_EN
(refer to chapter “
Fence Positioning
” / section “
Swivel-away Devices
”).
V
S
A
