BA_PH_245-100-300_EN_06-22.docx
53
16.9.3
Adaptation to the Machine Table (only required for retrofitting)
ca. 275
ca. 300
440
Fräsdorn
Tischplatte
=
=
M12
M12
Figure 55: Adapt tenoning device (drilling sketch)
Mount the tenoning and slotting
device as close as possible to the
milling arbor.
The diameters of the largest and
smallest cutter heads used are deci-
sive for the distance to the milling
arbor.
•
Place the tenoning device on
the machine table (parallel to
the table edge).
•
Determine the distance to the
milling arbor and mark the cen-
tre of the crossed slotted holes
on the table top.
We recommend drilling the holes according to the sketch above, whereby the dimension 275 mm depends on
the cutter head diameter used.
•
For this purpose, two M12 threads must be fitted (bore diameter = 10.2 mm).
•
Fasten the tenoning device with M12 x 30 hexagon screws and washers.
16.9.4
Supplementary Protective Cover 1641 (Option)
The protective cover type 1641, also shown in
Figure 53, is an ideal complement to the tenoning and slotting
device type 1376. It is suitable for tenon cutting and slotted discs up to max. 350 mm. The cover is made of strong
sheet steel and has an adjustable protective hood as well as an extraction nozzle with an outer diameter of 120
mm. For article number see section
16.10
Kickback Guard Type 1648
Figure 56: Kickback guard type 1648
The kickback guard type 1648 is used for acci-
dent-free insertion milling of long and short
parts in combination with the optional table
extension.
It is infinitely adjustable from 0 to 1500 mm
and intuitive to operate.
Article number see section
Milling arbor
Table top
approx. 300
approx. 275
