BA_PH_UT300_EN_18-21.docx
15
Height Offset
Input of the
effective height
(incl. calculation of the tool, etc.) in the range from 0 to 125 mm:
Figure 12: Effective height (incremental)
The setting range depends on the inserted tool and is also calculated accordingly
(see display "min" and "max").
Action Function
Confirmation of input + positioning enable
→
The positioning button
flashes
Further actions:
Action Function
With this "
Reset-Icon
" the axis can be set to "0".
Perform calibration with the "
Zeromaster
" reference measurement adjusting unit
(see section
9.2.1 below).
9.2.1
Zeromaster
With the Zeromaster (accessorial part, Art. No. 2205) it is possible to measure the effective tool
height with the machine and to reference the machine incrementally to this dimension. This function
is very helpful to compensate the mechanical play of the spindles.
To perform this function, press the "
Zeromaster
" button and follow step by step the instructions on
the screen.
