Panini I:Deal, Operator'S Manual

Operator Manual 

Page 7 

Operating the I:Deal 

3.3. LED 

Indicators 

The 3-color LED on the top cover of the device indicates 
the machine’s status. The following table indicates the 
meaning of each status light. 

LED 

Description 

Off 

Device disconnected or software not 
connected 

Yellow Blinking 

Device connected, software 
connected but pocket flaps are 
closed 

Yellow Solid 

Device connected, software 
connected, pocket flaps open 

Green Solid 

Device is ready to begin feeding 
(Device connected, software 
connected, pocket flaps open and 
feeding enabled) 

Green Blinking 

Machine is processing documents 

Red Blinking 

Document jam or misalignment  

Red Solid 

Firmware being updated 

3.4.  Document Processing / LED Cycle 

1.)  Once the unit is powered on, flaps are up and USB 

cable connected the status LED will turn solid 
yellow, indicating initial power and PC connection to 
the device. 

2.)  When the application requests to start feeding the 

LED will turn solid green. Once a document is 
loaded into the feeding tray the machine will detect 
the document and begin scanning. The LED status 

will begin blinking green indicating that the machine 
is busy processing a document. 

3.)  After scanning the machine will stop with the 

document either in the exit pocket or feeding tray 
according to the processing mode. If exiting to the 
feeding tray the LED will continue flashing green 
until document is removed from the tray. Once 
removed the LED will have be solid green indicating 
it is ready to process the next document. 

4.)  A flashing red LED indicates that either a document 

jam or misalignment has been detected. The 
machine will stop the document in the track to 
prevent capturing a misaligned document or to 
prevent damaging a jammed document. If 
misaligned, remove document and begin scanning 
again. For jammed documents see section 5.1 on 
how to remove jammed documents. 

5.)  A flashing yellow LED indicates that either the top 

flaps are closed or the top cover is open. 

3.5.  Opening / Closing Top Cover 

The top cover of the device can be easily opened for 
removal of jammed documents, cleaning the device or 
for replacing the franking roller. 

1.) To open the top cover press the blue release button 
on the top side of the feeding tray and lift the cover up. 

2.) To close the cover press firmly downwards in the 
middle of the top cover. Ensure that both sides of the 
scanner securely snap closed.