5-6
Original’s Insertion Slot
5.3 Removing the Original Pressure Platen
To remove the original pressure platen fixture when cleaning the
scanning area, press down the platen fixture while sliding the left and
right extended media thickness adjustment sliders fully towards the
middle of the platen. This allows you to fully disengage them from the
scanner and lift out the original pressure platen fixture.
To reinsert the original pressure platen, reverse the above procedure.
Figure 5-2 Slider in the exit position
A small locking pin will keep the slider in the exit position to facilitate
removal and insertion of the original pressure platen.
