12
13
an SD card port, simply use the provided USB cable to connect the Panta® Pocket
Cam to your computer/laptop. Plug the Micro-USB connector end of the USB cable
into the camera (Figure K). Once the Micro-USB cable is plugged into the camera,
plug the other end of the USB cable into the USB port of your computer/laptop
(Figure L).
3. Access the footage by going to the drive associated with the Panta® Pocket Cam. Go
to the PHOTO & VIDEO folder to view the files. You can view, save, or delete recorded
videos & photos there.
USING CAMERA WALL MOUNT, TABLE STAND & CAMERA CLIP
Assembling the table stand
1. Hold the wall mount in one hand and the camera clip in the other.
2. Gently press the camera camera clip clamp together to open (Figure M1).
3. Insert the grooved base of the wall mount into the opening of the camera clip, and
allow the grooves to align (Figure M2).
4. Now the wall mount is fully assembled and is ready to be used as a table stand.
Using the camera clip
1. Place the camera clip on the back of the unit (Figure N). Gently press the camera
camera clip down until the clips enter the Panta® Pocket Cam mounting grooves,
located on the left and right sides of the camera.
NOTE: A faint click will indicate correct mounting. Make sure that the on/off switch
is positioned to the side when the unit is in use. To remove the camera clip, gently
slide the clips either up or down out of the camera mounting grooves.
Using the wall mount
1. To mount the Panta® Pocket Cam using the mounting tape provided, first peel off a
single side of the mounting tape and place on the back of the wall mount (Figure O).
2. Once the mounting tape is attached to the wall mount, simply peel the protective film
off of the other side of the mounting pad and press the unit firmly onto the mounting
surface (Figure P).
NOTE: The wall mount can be installed either vertically or horizontally.
3. After the wall mount is installed, adjust the angle of the camera by loosening the
wall mount base with a screwdriver (not provided) (Figure Q). When the desired
angle is achieved, tighten the wall mount base.
4. Make sure that the Panta® Pocket Cam logo is visible on the device, and that the
on/off switch is positioned to the side (Figure R).
M18205_PantaPocketCam_Manual_A5_20181031_KS.indd 13
29.11.18 11:00
