page- 6
Operating Manual PD1/PD2/PD3
2022 rev. 6.0
Keep hair, loose clothing, fingers, and all parts of body away from openings
and moving parts (accept during a filter cleaning procedure).
Make sure all the guards and protection devices are in place and that all
the safety devices are in place and working properly.
Do not open the vacuum container with the machine running.
Do not wear loose or hanging clothing such as ties, scarves or torn garments
that could become trapped and be sucked up by the cleaner.
Do not use without dust bag and/or filters in place. Replace collection
system and/or filters as described in manual.
Do not modify machine from its original design.
All repairs must be performed by a qualified service person. Use only
manufacturer supplied or specified replacement parts.
6
Electric safety
Improper connection of the equipment-grounding conductor can result in a
risk of electrical shock. Check with a qualified electrician or service person if
you are in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the machine. If it will not fit the outlet,
have a proper outlet installed by a qualified electrician.
Before using the machine, make sure that the power & voltage corresponds
with the voltage shown on the machines rating plate.
Do not leave machine when plugged in. Unplug cord from outlet when not
in use and before cleaning or servicing machine.
Cables damaged through crushing or splitting can be dangerous if used
and should be replaced immediately. Risk of personal injury.
Do not use with damaged cord or plug. If the machine is not working as it
should, has been dropped, damaged, left outdoors or dropped in water.
Make sure it is repaired by a qualified person.
Do not pull or carry by cord, use cord as handle, close a door on cord, or
pull cord around sharp edges or corners. Do not run the machine over cord.
Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug. Not the cord.
Do not handle plug or machine with wet hands.
Regularly inspect cord and plug for damage. If cord is damaged, it must be
replaced by a qualified person to avoid hazard.
Turn off all controls before unplugging.
Summary of Contents for PD1
Page 12: ...page 12 Operating Manual PD1 PD2 PD3 2022 rev 6 0 13 Exploded view and part list PD1 ...
Page 17: ...page 17 Operating Manual PD1 PD2 PD3 2022 rev 6 0 14 Exploded view and part list PD2 ...
Page 22: ...page 22 Operating Manual PD1 PD2 PD3 2022 rev 6 0 15 Exploded view and part list PD3 ...
