3
Transmitter Instructions
WARNING: Never operate the wireless remote from outside the boat
Before you can operate the device the transmitter must be learned to the receiver. This is very easy turn on your
transmitter. You will see the LED blink two times. Press one of the activation buttons and hold it down. Apply
power to the receiver device while continuing to press the transmitter activation button and you will hear the
relay click.
Be Careful the device may start operation.
If you experience problems repeat the process again.
After the transmitter is learned you should not have to repeat this process again
Place the transmitter in the palm of your hand . You will see three buttons. The button to the lower left turns the
transmitter on and off after use. Press this button a red LED will blink twice and go out letting the operator
know the unit is activated and ready for operation. Press the button again, the LED will blink once shutting the
unit down. The unit will shut down automatically if you fail to turn it off or there is no activity on the activation
buttons for a period of five minutes.
The activation buttons are located above the power button and have raised surfaces. The two buttons are used to
activate the device after the transmitter is turned on.
.
This Device complies With the FCC Part15. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired oper-
ation.
Section 15.105 Information to the user Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates ,uses , and can radi-
ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not approved by MarineTech Products, Inc. voids user’s authority to
operate this
equipment
POWER INDICATOR LIGHT
[DOES NOT REMAIN ON DURING OPERATION]
ACTIVATION BUTTON
ON/OFF BUTTON
