Panther PA-420C, Installation Manual

128-9239

10 of 24

Page 10

7 Flashes

Tach signal has not been learned

8 Flashes

Negative inhibit wire activation

TIMED START OPERATION:

To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF
command to start 2 times. (Press the start button four times). The lights will flash and the
horn will beep 2 or 4 times, indicating timed interval mode has been initiated. The vehicle
will automatically start every 2 or 4 hours as programmed. To cancel the timed start mode
start the vehicle either by RF or by the ignition key.

4 PIN DATA BUS PORT (DBI Port)

The 4 pin port located on the side of this module is for proprietary Audiovox data bus
interface modules. These modules are used to access a variety of features in the vehicle
which can be as simple as door trigger inputs, to more complex door lock outputs, or
transponder interfaces for remote starting. DO NOT connect anything to this port other
than the Audiovox DBI interface  modules or damage to the Remote Start will occur. All
installation instructions for the DBI modules will be packaged with the individual
component along with the proper 4 pin wiring harness requires to access the data transmit
and receive as well as the proper voltage levels for the interface.

COMPLETING THE INSTALLATION:

After you have confirmed the operation of the Audiovox Remote Start unit and tested all the
safety features of the system:
1.  Mount the control module up and behind the dash securing it in place with cable ties or

screws. Be certain that the chosen mounting location will not inhibit any of the controls
of the vehicle.

2.  Securely harness and tie all wiring up and away from all hot and moving parts that they

may come in contact with under the dash board or in the engine compartment areas.

CAUTION:

Particularly avoid the area around the steering shaft and column, as wires
can wrap around these mechanisms and impair the safe operation of
the vehicle.

3.  Apply the Caution Labels supplied with this kit to a conspicuous area in the engine

compartment. Make sure to clean the surface before affixing the label.

4.  Check the vehicle's wipers, lights, horn, etc., to insure proper operation.
5.  Replace all panels that were removed during installation, and retest the system.
6.  Explain all activated features and safety systems associated with Remote Start Unit

installed to the customer.