3
128-9107
3 of 8
Second Vehicle Operation:
Press the Trunk/Key the Option button for 2 seconds, the LED flashes 2 times. Release the
buttons, then press any transmitter to select 2nd vehicle mode.
While in the 2nd car mode, press the Trunk/Key Option button for 2 seconds, the LED flashes 1
time to indicate the primary vehicle operation.
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your
system. To remove a transmitter that has been programmed in your system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a
chirp, then release and immediately press the same button a second time until you hear a long chirp
followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information below will
successfully remove the transmitter.
NOTE:
For this procedure, you must have all transmitters you wish to remain programmed in your system
available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock function of your unit
making sure you occupy all 4 transmitter slots. In other words, you have three transmitters you wish
to remain programmed. Press and hold the lock button of transmitter one until a long chirp is heard,
then press and hold the lock button of transmitter two, then press and hold the lock button of transmitter
three, followed by pressing and holding the lock button of transmitter one again. This action fills all 4
receiver slots.
3) With all transmitters programmed, turn off the ignition switch to exit the transmitter program mode.
If you are uncomfortable about the programming of additional transmitters as outlined in the processes
above please contact your installation center or call the technical service number listed on the back of the
transmitter for help.
