Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, +46-8-761 50 40, www.panthera.se
7) Slide the lower, magnetic, attachment
onto the lower part of the crutch. The lo-
wer attacment fits tube diameter 16,5 to
19,2 mm, including the plastic bushings.
Don´t tighten the screws yet.
8) Remount the crutch.
9) Hang the crutch with the upper at
-
tachment on the backrest tube. Turn
the crutch until the handle of the crutch
points backwards, away from the wheel
-
chair.
10) Tighten the screws by turns with a
small philips head screw driver (Bits PH
0). Use moderate force when tightening
the screws.
11) Adjust the lower, magnetic, attach
-
ment in height until it is level with the
chassis tube.
12 Tighten the screws by turns with a
small philips screw driver. Use moderate
force when tightening the screws.
13) Attach the crutch to the wheelchair
with its mounted attachments.
Repeat the procedure on the other
crutch, if there is one.
