Wired network setup (applicable to wired
In case printers support wired network printing, they can be connected to
network to
control printer to print in wired network mode.
DHCP automatic setting function is enabled by default on the printer.
1.
Connect the printer to the network through a network cable and complete
the startup
preparation work.
2.
The printer will receive the IP address assigned by server automatically.
It may take
server minutes to receive IP address under the influence of
network environment.
Note
：
• If DHCP server fails to assign IP address automatically, the printer
will get the link-local address assigned by printer automatically: 169.254.xxx.xxx.
You can check the IP address of printer by printing "Network setup page" out
for printing method) or check network information by
viewing the control panel of printer (please refer to
the IP address is not listed, please check network environment and then try again after
waiting for several minutes.
To set up IP address for printer through the control panel of printer manually,
for details.
To set up IP address for printer through the embedded Web server manually,
please refer to
The IP address of the printer may be automatically obtained through DHCP function or set
manually.
43
