background image

12

13

◎ Mute

Press the 

to mute, press again to release . The mute icon 

will show up on the screen.

◎ Emergency Lock

When it's recording , press Menu            button to lock the current 

footage from being overwritten.

S

hortcut Button

Troubleshooting

Check your vehicle's owner's manual to verify that 

you've connected the camera to a power outlet 

that only operates when the key is in the On or 

ACC position. If you have connected your camera 

accordingly and it still remains on when the car is 

turned off, please email service@mygekogear.com 

for assistance.

Camera does not turn off 

when the car is turned off.

The unit cannot take photos 

or record videos. The unit 

automatically stops when 

recording

General Problems

Possible Solutions

Video is unclear.

Ensure that there are no fingerprints or dirt on 

the lens. Ensure that the lens is always kept clean.

Horizontal stripe interference 

in an image.

●Ensure  that the micro SD  card is  formatted properly 

and inserted correctly.

●Use the recommended type of micro SD card

(minimum 8GB Class 10)

The unit crashes.

Verify that Frequency option (Settings/Frequency)

is set to 60HZ.
Using a pin or an unfolded paper clip, press and 

hold the Reset button (on the side of the device) 

to restart the unit.

Disclaimer

1

.Please follow the set-up and usage instructions in the print material that came with 

this
Dashboard Camera (dashcam) product.
2.You should not set/install this dashcam at a place that would obstruct or reduce a 
driver's view. Make sure your usage comply with pertinent vehicle codes of your 
state, province, territory or country.
3.You should post the required notices of recordation to occupants inside the vehicle, 
if voices or other information/signal pertaining to in-vehicle activities will be recorded.
4.You should not change the dashcam's setting or mode of operation when the vehicle
 is in motion.
5.You should not leave the dashcam in a visible spot when no one is inside the vehicle, 
to avoid attracting break-ins to steal the unit, or other property.
6.You should avoid extended exposure of the dashcam to direct sunlight or extreme 
temperatures (either high or low temperature) which tend to degrade or damage the 
unit and its normal functionality.
7.You should examine, check and/or verify the dashcam at least every six (6) months, 
including the associated memory cards, to ensure the video reception and recording are 
working properly. For each use, you should verify that the dashcam unit, the visible lights 
and the audible sounds are working normally. If there are signs of non-operation or 
malfunction, you should immediately seek to replace the product and check to see if the 
product is covered under any applicable warranty.
8.Thedashcam unit may have additional functionality, such as transmission and recordation 
of audible or GPS signal or other identification information. If you have privacy concerns 
about these functions, make sure you follow the instruction to disable these functions.
9.You should use the dashcam unit in the way it is intended. You should not use 
the dashcam unit in a way that would be illegal or that tends to physically damage the unit, 
or tends to cause danger to the safe operation of the vehicle or the occupants.
10. THIS DEVICE SHOULD NOT BE ADJUSTED BY THE DRIVER WHILE DRIVING.   IN THE EVENTOF 
AN ACCIDENT, DEVICE MAY DISLODGE AND BECOME UNSAFE FOR PASSENGERS.

.

Warning: This product may contain a chemical known to the State of California to cause cancer, 

or birth defects or other reproductive harm.

Summary of Contents for D108016G










Reviews: