mod. ASSO 260 - cod. 96721
- 20 -
Unpacking
1. Take all parts out of the packaging.
2. Check all parts for transportation damages. If you detect any damages or if parts are
missing, please contact your dealer.
Attention ! Always pull the plug and switch the device OFF, before you assemble
the device or replace parts.
Assembly
Assemble Chute
1. Align lower section with middle section.
2. Slide middle section over lower section, ensure inner divider slots
correctly into groove of lower section.
Secure Chute to Motor Section
1. Align complete chute section with motor unit and push into
position.
Note: A motor cut-out safety switch is located inside top section of motor. To ensure
starting, chute must be firmly located before finally locking into position.
2. To lock chute in position, fix the screw.
Secure Collection Bag
1. Position collar section of collection bag
up to collar of motor section.
Preparing The Vacuum/Blower For Use
Extension flex
Attention! A defective extension flex may cause electric shocks or fire. Check
the flex regularly and carefully for damages. The device must not be used with a
damaged extension flex; damaged flexes must be replaced.
1. Use a proper extension flex. For flex lengths up to 30m a flex type H07RN-F with a
diameter of at least 1.5 mm² must be used. A flex with a diameter that is too small leads to
voltage and performance losses.
2. The extension flex must be kept out of the working area.
3. The state of the extension flex must be checked regularly. Defective flexes must be
replaced.
Note: To avoid detaching power cable always check that it is attached firmly to securing
hook before using vacuum/blower.
1. Put the coupling of the extension flex onto the shears‘ plug. Make a loop with the
extension flex and push it into the recess.
2. Place the end of the loop round cable securing hook and ensure it is pulled firmly
enough to prevent it coming loose while operating the vac/blower.
