mod. ASSO 260 - cod. 96721
- 17 -
Vacuum Blower mod. ASSO260
1.
DESCRIPTION OF PACKING CONTENTS
n° 1 Vacuum Blower
n° 1 Collection Bag
n° 1 Instruction manual
2.TECHNICAL SPECIFICATIONS
Model
ASSO 260
CODE
96721
VOLTAGE
230-240V ~ 50 Hz
INSULATION
classe II
RATED POWER
2600 W
AIR VELOCITY
270 km/h
BLOW VOLUME
0,13 m
3
/s
DUST BAG
45 lt
MULCHING RATIO
10:1
Vibration: weighted acceleration m/s2.
2,291
Sound power level dB (A).
106 dB
WEIGHT
4,5 Kg.
Noise/Vibration Information
Measured values determined according to EN 60745.
Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is on the above table.
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 60745 and may be used to compare
one tool with another. The vibration emission level will vary because of the ways in which a
power tool can be used and may increase above the level given in this information sheet.
Note: To be accurate, an estimation of the level of exposure to vibration experienced
during a given period of work should also take into account the times when the tool is
switched off and when it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
3.GENERAL SAFETY INSTRUCTIONS
Intended use
The leaf vac is exclusively used in the two following ways:
1. As a leaf vac for vacuuming up dry leaves and pieces of paper.
2. As a blower it is used to collect together dry leaves or to remove them from inaccessible
places (e.g. under vehicles). In suction mode it also works as a shredder, where the
volume of the leaves is reduced by a ratio of approx. 10:1 and takes up less space in the
leaf collection bag and the collected material is simultaneously prepared for possible
composting. Each type of use other than those given in these instructions for use can
damage the machine and cause serious risk to the user. Please always observe the safety
instructions in order to safeguard your guarantee claim and in the interests of product
safety. Due to the machine’s design, we are unable to fully exclude all residual risks.
