Para Mobility PELICAN POOL & SPA HOIST, Installation Manual

INSTALLATION INSTRUCTIONS

PELICAN POOL HOIST

EARTHING: 

As per AS3000 of the 

wiring rules standards - “In certain 

circumstances” it may be necessary 

to have all conductive metal objects 

equally potentially bonded (earthed), 

this includes Pool Hoists.

We recommend you seek the advice 

and opinion of a qualified

electrician.

TOOLS REQUIRED

• 

Hammer Drill

• 

16mm masonry bit

• 

Hole Cleaning Pump

• 

Hole Cleaning Brush

• 

Cartidge gun - for adhesive

• 

Adhesive (included)

• Acetone

To safely install the Pelican Pool Hoist you will need a solid

concrete pad to anchor it to. We recommend that approximately 

1/3 of cubic metres of concrete is used when pouring your pad. 

This can be made up as a logical size, for example: 1000 x 1000 x 

300 or 650 x 650 x 650. The ideal location is placed up against the 

pool edge. It’s highly recommended to use a minimum of 20MPa 

concrete strength.

Place hoist in position, ideally around 100 to 500mm from 

edge of pool

 (can be further but check that lifting arm will reach 

into pool far enough to lower person into water). Check for

obstructions when arm of hoist is rotated. Use the hoist base as a 

template.

NB

 Anchors must be set into the concrete NOT into   the tile 

bed or pavers. If there are pavers surrounding the pool a 

concrete pad must be laid

 – contact Active Mobility Systems for 

instructions.

Drill 16mm diameter hole to a minimum of 100mm into

concrete substrate

. (Example: 100mm 

below

 any tile bed).

Remove dust and debris

 by brushing and blowing 3 times each 

(If hole is wet or flooded, remove water with wet/dry vacuum). Hole 

may be damp but must not be flooded.

Prepare all holes and socket studs

 before continuing onto 

next 

step.

Screw mixing nozzle onto Adhesive cartridge

 (supplied) and 

dispense 2-3 trigger pulls of adhesive to waste until colour is grey 

with no streaks.

Insert tip of nozzle

 to bottom of hole and dispense adhesive.

Fill hole

 to about 2/3 full.

Insert threaded stud socket

, with M12 threaded socket on top, 

with a rotating motion to release trapped air. Finish the top of the 

M12 threaded socket flush with finished floor, making sure that 

there is no adhesive in the threaded socket.

Wait until adhesive has fully cured before loading.
Clean up

 with acetone.

1.

2. 

3.

4.

5.

6.

7.

8.
9.
10.

11.
12.

Pelican Pool Hoist | 9