8
Chapter 2: Controls and Indicators
1. Battery Backup & Surge output receptacles: Mission critical equipment.
2. AC normal (Green) LED turns on during the AC normal mode and turns
off during the battery mode.
3. On/Off Button: Turns the UPS On or Off.
4. Input circuit breaker: Protection against an excessive overload.
5. On-Battery (Yellow) LED turns on during the battery mode and turns off
during the AC normal mode.
6. Warning / Fault (Red) LED turns is on when a Warning or Fault is
detected and turns off during normal operation.
7. Input power cord: Connecting to Utility Power.
8. Surge-only output receptacles: Noncritical equipment.
9. Alarm Silencer Button: Silences the alarm during the Battery mode.
10. USB Charging Ports Type ‘A’ (EN600GU Only).
11. USB Communications Port (EN600GU & EN750G only): UPS
monitoring and control.
Model
Input Power Cord
Output Power Receptacles
EN450G
NEMA 5-15P w/5 ft cord
4 - NEMA 5-15R Battery Backup & Surge
4 - NEMA 5-15R Surge Only
EN600GU
EN750G
5 - NEMA 5-15R Battery Backup & Surge
5 - NEMA 5-15R Surge Only
9
The AC normal (Green) LED will be on when the UPS is
operating in the normal AC mode and will turn off when the
UPS is operating in the Battery mode.
The On-Battery (Yellow) LED will turn on when the UPS is
operating in the Battery mode and will turn off when the UPS is
operating in the AC normal mode.
The Warning / Fault (Red) LED will turn on when the UPS
detects an internal fault, an Overload, a Weak / Bad /
Disconnected Battery, a Low Battery Warning, or a Site Wiring
Fault. The LED will be off when the UPS is operating
normally.
See the LED and Alarm functions table for more information.
The On/Off Button functions as follows:
When the UPS is in the Off position, press and hold the On/Off
button until the alarm sounds one beep and then release to turn
the UPS On.
When the UPS is in the On position, press and hold the On/Off
button until the alarm sounds one beep and then release to turn
the UPS Off.
When the unit is operating in Battery mode, pressing the Alarm
Silencer Button will silence the audible alarm. Once the UPS
reaches the LBW (Low Battery Warning) threshold the alarm
will start beeping. The alarm cannot be silenced during the
LBW alarm. Once the UPS transfers back to the AC normal
mode the alarm will reset back to the default setting.
Except for the On-Battery alarm all the other Warning/Fault alarms cannot
be silenced. Once the Warning/Fault condition has been corrected the
alarm will reset to default.
Summary of Contents for Minuteman Enspire Series
Page 19: ...34 Notes 35 Notes...