FIGURE 15
13
FIGURE 16
STEP 15
• Insert two GUIDE RODS (19) into the BASE (1) as
shown on FIGURE 15.
(NOTE: Lubricate GUIDE
RODS (19) with silicon or teflon spray available
at most hardware stores.)
• Slide two 1-1/4 X 4-7/8” TUBES (18), two 3/4”
WASHERS (56), and two WEIGHT STACK
CUSHIONS (29) -
IN THAT ORDER -
down over
the GUIDE RODS (19).
• Securely assemble the WEIGHT STACK SHAFT
(27) to the HEAD PLATE (26) using one 3/8 X 1-
1/4” BOLT (63) and one 3/8” LOCK WASHER
(52).
• Using
EXTREME CARE
slide all fifteen WEIGHT
PLATES (31) down over the GUIDE RODS (19) on
to the WEIGHT STACK CUSHIONS (29). Make
sure that the keyholes of the WEIGHT PLATES
(31) are all facing the right way.
• Insert two CAP PLUGS (45) into the top ends of the
GUIDE RODS (19).
• Slide the head plate assembly down over the GUIDE
RODS (19) onto the weight stack.
• Attach the WEIGHT STACK LABELS (71) to the
weight stack. Also insert the WEIGHT STACK PIN
(30) into the first WEIGHT PLATE (31) of the weight
stack.
18
3/8 X 1-1/4” 63
56
45
3/8” LOCK WASHER 52
27
31
30
19
29
26
1
STEP 16
71
•
SECURELY
assemble one 3-1/2” PULLEY
(34) to the FLOATING PULLEY BRACKET
(11) using one 3/8 X 2” BOLT (64), two 3/8”
WASHER (51), and one 3/8” LOCKNUT (50)
as shown in FIGURE 16.
64 3/8 X 2”
50
46
11
34
• Assemble one 2” SQ. RUBBER BUMPER
(46) to the FLOATING PULLEY BRACKET
(11) as shown in FIGURE 16.
51
