18
FIGURE 24
FIGURE 25
3/8 X 2-3/4” 38
26
28
14
78
51
51
35 3/8 X 1”
STEP 24
• Securely attach BACK SEAT PAD (26) to BACK PAD SUPPORT (14) using two 3/8 X 2-3/4” (38) and two 3/8” WASHERS (51).
• Securely attach LEG SEAT PAD (28) to HINGE TABS (78) using two 3/8 X 1” (35) and two 3/8” WASHERS (51) as shown in
FIGURE 24.
STEP 25
Assemble the LEG CURL/EXTENSION (4) to the LEG SUPPORT (15) using the following steps:
• Insert two 1/2” FLANGE BEARINGS (67)
into the LEG CURL/EXTENSION (4).
• Assemble the LEG CURL/EXTENSION (4) to
the BENCH FRAME (15) using one 1/2 X 3”
(42), two BOLT COVER CAPS (97), two
BOLT COVER WASHERS (98) and one 1/2”
LOW HEIGHT
LOCKNUT (50).
(NOTE:
Securely tighten, then back nut off 1/4 turn
to allow the LEG CURL/EXTENSION (4) to
rotate freely.)
35 3/8 X 1”
42 1/2 X 3”
50
4
48
67
90
1/2” LOW
HEIGHT
100
• Assemble one 3-1/2” PULLEY(79) to the LEG
SUPPORT (15) using one 3/8 X 3” BOLT (39),
two 3/8 X 1/2” SPACERS (99), one CABLE
RETAINING CLIP (58) and one 3/8” LOCK
NUT (48).
(NOTE: Make sure LEG EXT.
CABLE (90) is running under the PULLEY.)
• Assemble the ball end of the LEG EXT.
CABLE (90) to the KEYHOLE CLEVIS (100)
as shown in FIGURE 25.
•
SECURE
the KEYHOLE CLEVIS (100) to the
tab on the LEG CURL/EXTENSION (4) using
one 3/8 X 1” BOLT (35) and one 3/8” LOCK
NUT (48) as shown in FIGURE 25.
(NOTE:
Do not overtighten! Keyhole clevis should
rotate freely.)
39 3/8 X 3”
79
48
98
97
97
98
99
99
58
