11
WALL MOUNTING
If you are not comfortable performing the following mounting procedures, have a professional perform
the installation
(see your Dealer).
FLUSH TO WALL USING KEYHOLES
(Cinema™ 70, 90, CC, ADP, 110 L/R, 110 C, 220, 330
)
NOTE:
When mounting Cinema
™
center speakers, if you run speaker cable down the face of the wall,
apply self-adhesive bumper pads (included) to rear corners of enclosure to accommodate the cable.
1. Using #10 screws (not included) screw into the stud. (If model has two key holes, measure
distance apart and use two screws). If you cannot locate a stud, use appropriate mounting
hardware that will hold screws securely
(see your Dealer). Do not screw all the way in, head
should stand out approximately 3/8 inch (9.5 mm). With ADP
™
speakers, head should stand
out 1/8 inch (3 mm). With Cinema™ CC, head should stand out 5/16 inch (8 mm). If using
bumper pads add 1/8 inch (3 mm) to the amount head stands out.
2.
Connect speaker cables as outlined in “Speaker Connection” section of this manual.
3. Align keyhole to screw head, and using an “in and down” motion mount speaker to wall.
ANGLE BRACKETS
(included with 110 L/R and 110 C speakers only, optional use
) (Figs. 5a, 5b)
Angle brackets may be used to tilt your 110 C speaker up or down (Fig. 5c) to optimize clarity and
intelligibility, and to tilt your 110 L/R speakers slightly inward for better imaging.
NOTE:
Position bracket so that the speaker’s sound is directed toward the listening area.
1. Using appropriate screws and hardware (not included) mount bracket with supplied safety
strap to stud at desired location. If you cannot locate to a stud, use appropriate mounting
hardware that will hold the bracket securely to the wall
(see your Dealer).
2.
Screw two #12 screws (included) into the two 60-mm holes in the back of the speaker
enclosure—do not screw them all the way in, heads should stand out approximately 1/8 inch
(3 mm).
3.
Connect speaker cables as outlined in “Speaker Connection” section of this manual.
4.
Connect safety strap to speaker using #12 screw in the remaining hole.
5.
Hang speaker from bracket keyholes using an “in and down” motion.
