Paradox Marine Technical Support
1 (866) 929-4441
13
Table 2
Once it has acquired the traffic channel, the unit will cycle through the following two
states in normal operation (Table 3).
Table 3
The terminal will transmit its initial report (LED turns orange for ten seconds)
after successfully completing the above states. The total process for transmission will
normally take between three and six minutes. Providing that your terminal has been
activated and set up within an application, the data will be available within about one
minute of the actual transmission. Once the units LED is flashing green, a signal has
been acquired and the position is adequate.
If the unit is already activated and the owner has received login info, you can
view the terminal through the website below. Contact Paradox Marine if unit is not
activated and you require a service agreement.
*Note to installer: If the unit is not activated, unplug power from the control box. Only
reapply power after the antenna has been activated. If an un-activated antenna
remains on for an extended period of time it is sent a disable command. After which a
re-enable command must be sent back to the antenna to make it work again.
www.satamaticsdplus.com
Login name:
Password:
