Paradox Marine Technical Support
1 (866) 929-4441
4
Mounting
Once the location has been decided on, it is time to mount the unit. The control unit
has six possible mounting holes. For permanent fixing it is suggested that you use the
four holes at each corner of the flanged edges of the box (Figure 2).
Figure 2
1.)
Place the Control unit on the desired location according to the criteria above and
mark the four respective holes
2.)
Remove unit and predrill the holes
3.)
Place unit back in position and install screws Do not over tighten
Power
The NAV TRACKER has been designed to adequately work through your vessels 12
Volt Direct Current (DC) Battery bank. You simply need to supply the positive (+) and
ground (-) wires to the proper terminal connection and plug the other end into the control
box (Figure 3). Make sure that the DC source is constantly fed to the Control Unit
regardless of battery switch position. It is important that you use a multimeter to verify
constant voltage and polarity of the proposed connection points on your vessels DC
power bank. The Control Unit also has a 1 amp fuse to protect from shorts. It may be
necessary to crimp on a spade type connector to the end of the power cable for proper
connection to the power source. (not supplied).
