8 Installer’s Manual
Step 4:Now in “Module Programming Mode”.
Enter the keypad’s 8-digit
[
SERIAL
NUMBER
]
.
The keypad will emit a Confirmation Beep and the
[
PRG
]
LED will flash.
Step 5:
Enter the 3-digit
[
SECTION
]
you want to program.
The keypad will emit a Confirmation Beep. The
[
PRG
]
LED and
the numerical LEDs for any lt or previously programmed data will
illuminate.
Step 5:
Enter the required
[
DATA
]
.
Depending on the section entered, the data required may differ.
The control panel will now redirect all programming to the
selected keypad. Every time the
[
CLEAR
]
button is pressed it will
revert to the preceding step, unless entering data, in which case
it will erase the current data entry. Please note that the serial
number is located on the keypad's PC board.
3.2 P
ROGRAMMING
M
ETHODS
3.2.1 Feature Select Programming
Program sections
[001]
to
[005]
by enabling or disabling options.
Within the sections, numbers from
[1]
to
[8]
represent a specific
keypad option (
refer to the
Digiplex LED Keypads Programming
Guide
). Press the button corresponding to the desired option and the
digit’s LED will illuminate. This means the option is enabled. Press
the button again to extinguish the digit’s LED, thereby disabling the
option. Press the
[
ENTER
]
button when the options are set.
Summary of Contents for Digiplex DGP-620
