16 User’s Manual
4.4.1 Instant Arming with Delay
Instant Arming with Delay
functions like Instant Arming except
the installer can program certain armed zones within the
protected area(s) with an
Entry Delay Timer
. If these zones are
accidently triggered, the timer will start to allow you enough time
to disarm the area(s).
If enabled by the installer, the One-Touch Buttons
(section 4.6) or a keyswitch (section 4.7) can also be
used to arm the area.
4.5 F
ORCE
A
RMING
Force Arming allows you to arm your system when specific
zones are open. Certain zones can be programmed by the
installer to remain unarmed when you initiate Force Arming.
Once the open zone is closed, however, the system will then arm
How do I Instant Arm?
1) Enter your
[
ACCESS
CODE
]
.
After Confirmation Beep, “Access Granted” should appear.
2) Press the
button.
If you have access to more than one area, press the area’s
number, press the
button for all areas, or use the
and
buttons and press
when the area you want
to Instant arm appears.
After the Confirmation Beep, “Instant Arming” will appear
briefly on LCD screen and the exit delay timer will begin.
Summary of Contents for Digiplex DGP-641
