10
Reference & Installation Manual
3.6 Level Programming
In the sections requiring Level Programming, only one option can
be selected.
For LCD keypads:
To select the option, use the [
S
] and [
T
] keys until the desired
option is visible and then press [
ENTER
] to save.
For Grafica keypads:
To select the option, use Grafica’s scroll keys until the desired
option is visible and then press Grafica’s center action key (Save)
to save.
3.7 Paradox Memory Key
The Paradox Memory Key is not verified by UL.
Copy the programmed contents of one Digiplex control panel into
the Paradox Memory Key. Then copy the contents of the Paradox
Memory Key into as many Digiplex control panels as you need.
This saves you a lot of time. All you have to do is program one
Digiplex control panel, then download the programmed contents to
other control panels in less than 5 seconds.
Figure 12: Using the Memory Key
Copy to Memory Key from SOURCE Control Panel:
1)
Remove the AC and battery
power from the control panel.
2)
Place Memory Key on the
connector labeled
MEM
KEY
of the
control panel that you want to
copy. Make sure that the write
protect jumper is on.
3)
Enter section:
[965]
to copy the contents of the panel
except sections
[001] to [048]
(device serial numbers)
and [049] to
[056]
(keyswitch serial numbers) to the key.
[966]
to copy all of the contents including
sections [001]
to [048]
and [049] to [056]
from the panel to the key.
4)
When the keypad emits a Confirmation Beep, wait 10 seconds
before removing the Memory Key. Remove the jumper if you
do not wish to accidentally overwrite the contents of the
Memory Key.
Download to DESTINATION Control Panel:
1)
Remove the AC and battery
power from the control panel.
2)
Place the Memory Key on the
connector labeled
MEM
KEY
of the
control panel that is to receive the
contents of the Memory Key.
3)
Enter section:
[961]
to download the contents
except sections [001] to
[048]
(device serial numbers)
and [049] to [056]
(keyswitch serial numbers) from the key to the
panel.
[962]
to download all of the contents including
sections
[001] to [048]
and [049] to [056]
from the key to the
panel.
4)
When the keypad emits a Confirmation Beep, wait 10 seconds
before removing the Memory Key.
Insert Paradox Memory
Key onto the connector
labeled MEM KEY
Write Protect Jumper
Jumper On
= Read from & write
to memory key
Jumper Off
= Write protect (read
from memory key
only)
Partial view of the
Digiplex control panel
Summary of Contents for Digiplex DGP-848
Page 2: ......
