Digiplex/DigiplexNE LCD Keypad 7
n
case it will erase the current data entry. Please note that the
serial number is located on the keypad's PC board or enter
section [000] in Step 3 to v iew the keypad’s s erial number.
3.2 Programming Methods
The following methods can be used when programming the
keypad:
3.2.1 F eature Select Programming
Some sections are programmed by enabling or disabling
options. Within the sections, numbers from
[1]
to
[8]
represent a spec ific k ey pad option. Press the key
c orresponding to the desired option and the digit will
appear in the display. This means the option is enabled.
Press the key again to remove the digit from the display
thereby disabling the option. Press
[
E NTER
]
when options
are set.
3.2.2 Decimal Prog ramming
Some sections require that a dec im al value be entered. In
this method, any digit from 000 to 255 can be entered.
3.3 Module Broadcast
The control panel’s Module Broadcast feature c an be used to
copy the contents of one keypad to one or more keypads.
1. From Normal Mode press and hold the
[0]
key.
2. Enter
[
INSTALLE R
CODE
]
(default: 000000).
3. Enter section
[954]
(DGP-48) /
[4004]
(DGP-NE96).
4. Enter the
[
SE RIAL
#]
of the s ource k ey pad. T he
s ource
is
the programmed k ey pad whos e data y ou want to copy to
Summary of Contents for DigiplexNE DGP2-641
