The keypad will now automatically revert to factory default val-
ues, and all installer programmed information will be erased.
Teaching a Keypad Program to Another Keypad
Once the initial keypad in a system has been programmed, the
programmed information found at addresses
01 - 25
can be
taught to other keypads by doing the following:
1- Connect the special serial cable with four-pin connector to four
pins located in bottom left corner of the back of the master
or source 640 keypad. Similarly, connect the other end of the
cable to the four pins on the back of the slave or destination
640 keypad. The master keypad requires no other wires at
this time; the slave keypad should be connected to a panel.
2- The slave keypad should be in normal operating mode, not
in programming mode.
3- Press
[
ENTER
] [
INSTALLER KEYPAD CODE
] [
TRBL
]
on master
keypad.
4- Wait 10 seconds.
The programming information has now been taught to the
second keypad. Disconnect the serial cable and repeat these
steps as required for any additional keypads.
The [
INFO
] key
This key can be used when both the control panel and keypad
are in any operating mode (except installer/ user keypad pro-
gramming modes), whether the system is armed or disarmed.
IM640
16
When the
[
INFO
]
key is pressed, the LCD display will read:
INFORMATION ON
? :
PRESS A KEY
In any mode, (exceptions noted above) pressing on the key for
which additional information is required will bring up a brief
explanation of the keys function in the display.
Example
: In
trouble display mode, pressing
[
INFO
]
, followed by any key
from
[1] - [12]
, will cause a description of the trouble condition
represented by that key to appear in the LCD display.
In regular mode, if the key selected is a numbered key from
[1]
to
[12]
, the description of that zone will appear in the display. For
systems with more than 12 zones, the
[2
ND
]
key should be
pressed before pressing the
[
INFO
]
key to view zone descriptions
for zones 13-24. (Reminder: when the
[2
ND
]
key is pressed,
[1]
represents zone 13,
[2]
represents zone 14, and so on.)
One key access panel programming mode:
The
[
INFO
]
key can also be used to view a description of sever-
al of the functions of one-key access programming keys. To
view these descriptions, press
[
ENTER
]
, followed by installer,
master or user code 1. The keypad is now in key access pro-
gramming mode.
Press
[
INFO
]
for a brief explanation of
[
MEM
]
,
[
BYP
]
,
[
TRBL
],
[
AWAY
]
and
[
STAY
]
key functions (listed below). After viewing
explanations, to access these functions, press
[
CLEAR
]
, fol-
lowed by the required key(s). (For a full explanation of key
access programming, please refer to the Installation manual.)
IM640
17
