Special codes
(Addresses 184-193)
SECTION 31 - 33
These codes are assigned to report 10 special status conditions.
Panic 1
Panic alarm will be reported to the central. (keys [1] and [3] pressed for 2 seconds)
Panic 2
Panic alarm will be reported to the central. (keys [4] and [6] pressed for 2 seconds)
Panic 3
Panic alarm will be reported to the central. (keys [7] and [9] pressed for 2 seconds)
Partial arming
Will be reported if system is armed with zones bypassed.
Arming with Espload/
When Espload is used to arm the system, or when system arms itself automatically
auto arming
following a period without movement, a special report code will be generated.
Arm with master code
Using the master code to arm the system will generate a special report code.
No movement/
When the system is not armed, if there is no movement in the protected area for
late to close
a designated time period, or if the system has not been armed at its usual time,
a special report code will be generated.
Tamper report
The hexa digit entered for this report code will replace the first digit of all zone
alarm report codes when tamper "trouble" occurs. This identifies zone location
of the tamper "trouble" to the central. (auto-generated codes) If the
Zone Doubler
is activated, the tamper zone location reported represents a pair of zones.
Disarm with Espload
Using Espload to disarm the system will generate a special report code.
Disarm with master code Using the master code to disarm the system will generate a special report code.
Two digit hexa codes should be assigned to the trouble/special conditions that should be reported. All
digits from 1 - F are valid.
COMMUNICATOR FORMATS
(Address 194)
Contact I.D. event codes
Ademco Contact ID (all codes reported)
(key [10])
All report codes are preprogrammed in this DTMF reporting format. There is no need to program values
for addresses 088 -193. Contact ID event codes are listed below:
Ademco Contact ID (selected codes reported) (key [9])
Select certain report codes to be reported by entering any value other than [2
ND
][2
ND
] at the required
addresses. The preprogrammed Contact ID report code for that event will then be reported. Default value
of all addresses is [2
ND
][2
ND
].
Ademco Express
(key [8])
This high speed reporting format communicates events in 2 seconds.
DTMF - no handshake
([
TRBL
] key)
This format can be used in reporting situations where a central station receiver is not connected to the tele-
phone number. It's useful for personal reporting where a "handshake" is not required. (In "double reporting"
mode, first central station number can be connected to a receiver, while second can be used for personal
reporting using "no handshake" format. The panel will make two attempts to call the "no handshake" number.
Standard pulse formats (Ademco slow, Silent Knight, Sescoa, Radionics) are programmable with keys
[2
ND
] to [7].
24
IM8
