Arming
5
10
EVOHD User Manual
Arming
5
When your system is armed, it can respond to any breach in the protected zones by causing an alarm and sending a
report to your monitoring station.
5.1 Exit Delay Timer
When you arm your system, it will trigger the Exit Delay Timer to provide you with enough time to exit the
protected area before the system is armed.
5.2 Regular Arming
This method is used for the everyday arming of your system. All zones within the protected area must be closed
to Regular arm the system.
To Regular arm the system:
1. Enter your
[
ACCESS
CODE
]
.
2. Press the
[
ARM
]
button.
3. If you have access to more than one area, select the area(s) you wish to Regular arm (refer to
5.3 Stay Arming
Stay arming will partially arm your system to permit you to remain in your home or office by arming the outer
zones (perimeter) of the protected area (i.e. doors and windows).
To Stay arm:
1. Enter your
[
ACCESS
CODE
]
.
2. Press the
[
STAY
]
button.
3. If you have access to more than one area, select the area(s) you wish to Stay arm (refer to
).
5.4 Instant Arming
This feature is the same as Stay arming except that there is no Entry Delay. Therefore, any armed zone that is
breached will immediately generate an alarm.
To Instant arm:
1. Enter your
[
ACCESS
CODE
]
.
2. Press the
[5]
button.
3. If you have access to more than one area, select the area(s) you wish to Instant arm (refer to
5.5 Force Arming
Force arming allows you to quickly arm your system when zones are open. However, once the open zone is
closed, your system will then arm that zone as well.
