Disarming
6
14
EVOHD User Manual
Disarming
6
When your system is disarmed, it deactivates any alarms in progress, and it deactivates the zones so the alarm
will not be triggered if zones are breached.
6.1 Entry Delay Timer
Your installer will program designated entry points (i.e. the front door) with an Entry Delay Timer. This delay
gives you time to enter the armed premises and enter your code to disarm your system before the alarm is
triggered.
6.2 Disarming an Armed System
You can only disarm an area to which your user access code is assigned. User access codes with the
“Arm Only”
(
) option enabled cannot disarm an armed system.
To disarm the system:
1. Enter your
[
ACCESS
CODE
]
.
2. Press the
[
DISARM
]
button. If you have access to more than one area, select the area(s) you wish to disarm
(refer to
To disarm a system in alarm:
1. Enter your
[
ACCESS
CODE
]
.
2. In the case of a false alarm, call your monitoring station quickly to advise them of the false alarm.
W
ARNING
:
In the case of a burglar alarm, leave the premises and call the Police from a safe location.
6.3 Alarm Memory Display
When an alarm occurs in a zone:
• The area and zone (i.e. Alarm Area 1 - Front Door) are displayed / zone’s LED flashes even when the system is
armed. The notification continues until disarming, even if the zone is restored.
• The alarm memory will be erased after the next alarm occurs and a valid code has been entered.
To view the alarms that occurred the last time the system was armed:
1. When the system is disarmed, the LCD keypad’s screen will display
Alarm in Memory: Press [mem].
2. Press the
[
MEM
]
button.
Each zone that was breached while armed will appear below
Alarm in:
.
The
M
EM
action light will flash and the numerical light(s) for each zone whose alarm was triggered will illu-
minate.
3. Press the
[
CLEAR
]
button to exit the Alarm Memory Display.
