EVOHD User Manual
15
Access Codes
7
Access Codes
7
Access Codes allow access to the system. Your system supports up to 999 user access codes. Codes are given a
User Number
between 002 and 999 (User Number 001 is the System Master Code). Your installer will program
user access codes to be four, six, or variables of one to six digits in length. Each digit can be any value between
zero and nine. If your installer programmed your system to accept a variable code length, you have to press the
[
ENTER
]
button after entering your user access code.
7.1 System Master Code
The System Master Code will give you access to all the features available on your system, as well as the ability to
add, modify, or delete any user access codes. We suggest that you change this code to prevent others from
accessing and changing options without authorization. Your installer can set the System Master Code to be
either 4 or 6 digits in length.
To change the System Master Code:
1. Enter the current
[S
YSTEM
M
ASTER
C
ODE
]
(Default 1234 for 4 digit code; 123456 for 6 digit code).
2. Press the
[0]
button.
3. Press the
[
ACC
]
button.
4. Enter the numbers
[001]
.
5. Enter a
[
NEW
CODE
]
.
6. Press the
[
ENTER
]
button to save and
[
CLEAR
]
to exit.
W
ARNING
:
The System Master Code has access to all Access Control doors and all Access Control
features at all times. Only the card’s serial number and the choice of arming method can be
changed. If the other options are manually changed, the System Master Code will
immediately revert to its original programming.
N
OTE
:
You can assign a label (name) to a user access code at any point during the “Programming User Access
Code” process. Refer to
to assign a User Label.
7.2 Copy User Options
This feature allows you to copy the User Options, Access Control Options, and Area Assignments from one user
access code to another. All User Options are copied except the User Code, Card Assignment, and User Label.
To copy user options:
1. Enter your
[
ACCESS
CODE
]
(User access code with Master feature).
2. Press the
[0]
button, and then the
[
ACC
]
button.
3. Enter the 3-digit User number you wish to copy TO.
4. Press the
[
MEM
]
button.
5. Enter the 3-digit User number you wish to copy FROM.
