background image

English

Technical Specifications

All specifications are subject to change without notice.

Tricolour LED Display

The R910 reader includes a tricolour LED display (red, green and 

amber) that is used to indicate the reader’s status. The LED’s inten-

sity is adjusted through the Access Control Module (ACM).

Audible Tone

The R910 reader includes a built in beeper with a frequency that is 

adjusted through the ACM.

Weather Resistant

Mount indoors or outdoors.

Error Display

All R910 readers display communication errors between the reader 

and the ACM by flashing the amber LED every second.

Firmware Upgrade

Connect the CV4USB as shown in Figure 2. Refer to the CV4USB 

installation manual for additional information.

Mounting on Metal

Metal may decrease the read range. The R910 card reader can be 

mounted on metal but do not surround it by metal. If the reader must 

be installed in a metal enclosure, ensure that the face of the card 

reader is not covered and that there's at least 4cm (1.6") between 

the card reader and the metal on all sides.

Warranty

For complete warranty information on this product please refer to the Limited Warranty Statement 

found on the website www.paradox.com/terms. Your use of the Paradox product signifies your     

acceptance of all warranty terms and conditions
© 2018 Paradox Security Systems Ltd. All rights reserved. Specifications may change without prior 

notice. One or more of the following US patents may apply: 7046142, 6215399, 6111256, 6104319, 

5920259, 5886632, 5721542, 5287111, 5119069, 5077549 and RE39406.
Digiplex EVO is a trademarks or registered trademark of Paradox Security Systems Ltd. or its affiliates 

in Canada, the United States and/or other countries. For the latest information on products approvals, 

such as UL and CE, please visit www.paradox.com.

RESIDENTIAL EQUIPMENT

CLASS B DIGITAL DEVICE

INFORMATION TO USER

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-

tions: (1) This device may not cause harmful interference, and (2) This device must accept any inter-

ference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B Digital Device, pursu-

ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur 

in a particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-

nected

• Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by the party responsible for compliance could 

void the user's authority to operate the equipment.

Power Input:

11Vdc to 14.5Vdc

Current Consumption

100mA, with card 115 mA

Frequency:

Exciter field 125 KHz pulse modulated

Operating Temperature:

-35°C (-31°F) to +65°C (149°F)

Output Formats:

RS-485

Cable Distance:

300m (1000 ft.)

Cables:

4-wire Cables (twisted pair recommended)

Compatibilities:

Access Control Module (ACM) Series

4-Wire Indoor/Outdoor Proximity Reader

R910 V4.50

R910-TI04

Printed in Canada 09/2018                                                 PARADOX.COM

ACM12 shown

Se muestra el ACM12

ACM12 illustré

Figure 1: 4-wire Connection / Conexión de 4 Cables 

/ Raccordement à 4 fils

1.

Red / Rojo / Rouge

2.

Black / Negro / Noir

3.

Green / Verde / Vert

4.

White / Blanco / Blanc

Figure 2: Firmware Upgrade / Actualización del Firmware / 

Mise à niveau du micrologiciel

1.

Red / Rojo / Rouge

2.

Black / Negro / Noir

3.

Green / Verde / Vert

4.

White / Blanco / Blanc

To computer

A una PC

Vers l’ordinateur

CV4USB

Do not connect more than one 

R910 on a single ACM.

No conectar más de un 

R910 por cada ACM.

Ne pas raccorder plus d’un 

R910 sur un seul ACM.

Supply / COMBUS

Alimentación / COMBUS

Alimentation / COMBUS

Jumper is ON.

El puente está ON.

Le cavalier est installé.

Reviews: