Fire and Burglar Alarms
Page 39
Chapter 11: Fire and Burglar
Alarms
Standard Fire Zone
During a fire alarm, the bell/siren emits an intermittent
sound (
BEEP
-
BEEP
-
BEEP
) until silenced or reset. If the zone is
a Standard Fire Zone, your system can immediately send
an alert to your monitoring station.
To disarm a false alarm:
1) Enter your
user code
on the keypad.
2) Call your monitoring station quickly to advise them of
the false alarm.
WARNING:
The Fire Zone may reset itself once the problem
has cleared. If it does not, simultaneously press and hold the
[
CLEAR
]
and
[
ENTER
]
buttons for two seconds.
Delayed Fire Zone
If the zone is a Delayed Fire Zone, there is an automatic
delay before your system contacts your monitoring
station. Refer to Figure 2 on page 41 to prevent
unnecessary reporting of false alarms.
If the fire alarm is accidentally triggered:
1) Press
[
CLEAR
]
within 30 seconds of the alarm.
2) Clear the problem from the area (i.e., clear the smoke
from around the smoke detector).
3) If the problem remains after 90 seconds, the alarm will
sound again. Press
[
CLEAR
]
again.
4) The system will delay reporting the alert for another
30 seconds.
NOTE:
If you are unable to cancel the false alarm, your
system will send an alert. Call your monitoring station to
advise them of the false alarm.
WARNING:
The Fire Zone may reset itself once the smoke
has cleared. If it does not, simultaneously press and hold
[
CLEAR
]
and
[
ENTER
]
for two seconds or speak to your
installer.
Summary of Contents for K656 Touch Sense
