Page 5
Introduction
Chapter 1: Introduction
The PCS200 provides Paradox control panels with wireless communication
capabilities to report system events through a GPRS or GSM network to the
IPR512 GPRS/IP Monitoring Receiver.
The PCS200 can be configured to send system events to the
end-user via SMS, and can remotely upload/download with WinLoad software
via GPRS. All this is achieved via a simple 4-wire serial connection between
the control panel and the PCS200.
The PCS200 can be installed up to 2m (6 ft.) from the panel. The device’s
antenna can be installed up to 18m (60 ft.) from the reporting device using an
optional antenna cable extension, depending on the local signal strength.
Features
•
Report events to the IPR512 GPRS/IP Monitoring Receiver via GPRS or
to a landline receiver via GSM
•
Fast upload/download with WinLoad or NEware via a GPRS connection
•
Firmware upgrades via GPRS, or directly on-site
•
Report via text message (up to 16 cell phone numbers)
•
Control panel communication supervision. When detected, the control
panel will generate a trouble as well as report it to the monitoring station
via landline
•
End user can arm or disarm the system by sending a text message
(SMS) to the PCS200 -
GSM mode
•
Send pre-recorded voice messages to up to 8 phone numbers to report
alarms using the Paradox Plug-In Voice Module (VDMP3) -
GSM mode
•
Simple installation with 4-wire serial connection
•
Module antenna can be installed up to 18m (60ft) from the module using
optional antenna cable extensions depending on the local signal
strength
•
128-bit (MD5) and 256-bit (AES) encryption -
GPRS mode
