Parakey 13
3.0 HOW TO PROGRAM
Press the [
CLEAR
] key at any time to revert to the
preceding step, unless entering data, in which
case you will remain in the section and the current
data entry will be erased.
3.0.1 Step 1 - Enter the Programming Mode
When in "Normal Mode", the red LED on the
Parakey Receiver flashes on and off at 2-second
intervals. To enter the Programming Mode, press
the "
PROG
" button located on the Parakey
Receiver. The program keypad will beep once, the
red LED will flash and the keypad's "ready" light
will illuminate.
If at any time you wait longer than 2
minutes between each key entry, the
Parakey
will
automatically
exit
the
Programming Mode.
3.0.2 Step 2 - Key in Installer Code
Press [
ENTER
] and key in the [
INSTALLER CODE
].
The [
ENTER
] key will flash. Default installer code:
[757575]
Summary of Contents for PRK-315
