Parakey 19
face, whereas the Parakey remote control has no
such label. Remote Control Recognition instructs
the receiver module of the remote control type
being used. Enter section [35], then set option [3]
ON or OFF.
4.3.3 Remote Control Assignment
Sections [09]
[09]
[09]
[09] to [16]
[16]
[16]
[16] - RF Programming
Every time a button is pressed on the remote
control, it transmits its RF code to the Parakey,
identifying it as a user in the system. Therefore,
each remote control in the system must be
assigned to a user. After entering the section
corresponding to the desired user (see Figure 6
on page 17), press the [
ENTER
] key and the
“
READY
” and “
ARM
” lights will illuminate. Then
press button 1 on the remote control once, the
Parakey will beep once. Press button 1 again for
confirmation, the Parakey will beep twice to
indicate that the remote control was successfully
assigned. One long beep indicates that remote
control assignment was unsuccessful (i.e. remote
control already assigned to another user). To
delete a remote control, enter the desired section,
press the [2
ND
] key and press the [
ENTER
] key.
Key [3] ON
= Omnia Remote Control
Key [3] OFF = Parakey Remote Control
Summary of Contents for PRK-315
