3
3. Plug the end of a third cable into the POTS splitter jack labeled LINE. Plug the
other end into the line from the local loop.
For RTU installation information, refer to the
HotWire 5446 Remote Termination Unit
(RTU) Customer Premises Installation Instructions,
Document No. 5446-A2-GN10.
Indoor POTS Splitter Technical Specifications
Item
Specification
1
Width x Depth x Height
3.63
″
x 5.78
″
x 1.52
″
(9.22 cm x 14.68 cm x 3.86 cm)
Weight
6.7 ounces (190.0 grams)
Approvals
Safety Certifications
Refer to the equipment’s label for approvals on product.
Physical Environment
Operating temperature
Storage temperature
Relative humidity
Shock and vibration
32
°
F to 122
°
F ( 0
°
C to 50
°
C )
– 4
°
F to 158
°
F ( –20
°
C to 70
°
C )
Up to 95% ( noncondensing )
Withstands normal shipping and handling
Interface Connectors
Three 6-pin, non-keyed RJ11 modular plugs
1
Technical Specifications subject to change without notification.
Important Safety Instructions
1. Read and follow all warning notices and instructions marked on the product or
included in the manual.
2. This product is intended to be connected to Listed/Certified telephone wiring with a
minimum of 26 AWG (.4 mm) behind a Listed/Certified primary protector.
3. Do not attempt to install or service this product yourself, as opening or removing
covers may expose you to dangerous high-voltage points or other risks. Refer all
servicing to qualified service personnel.
4. When installed in the final configuration, the product must comply with the
applicable Safety Standards and regulatory requirements of the country in which it
is installed. If necessary, consult with the appropriate regulatory agencies and
inspection authorities to ensure compliance.
