3. Configuration Using the Web Interface
3-4
August 2005
8900-A2-GB20-50
Line Code
Select a line code:
MultiMode - The port uses the line code of its partner
modem
ANSI T1.413 - The port uses DMT modulation
ITU G.dmt Annex A - The port uses G.992.1 Annex A
modulation
ITU G.dmt Annex B - The port uses G.992.1 Annex B
modulation
ITU G.lite - The port uses G.992.2 modulation
ADSL2 Annex A - The port uses G.992.3 Annex A
modulation
ADSL2+ Annex A - The port uses G.992.5 Annex A
modulation
DSL Line Profile Name
Enter the name of a DSL line profile to set rates for the
port.
DSL Alarm Profile Name
Enter the name of a DSL alarm profile to set alarm
thresholds for the port.
ADSL2 PSD Profile Name
Select a PSD profile from the drop-down list.
ADSL2+ PSD Profile Name
Select a PSD profile from the drop-down list.
Power Management
Specify whether power management is supported on this
port:
Enabled - Power management is enabled
Disabled - Power management is disabled
Power management refers to the following modes, defined
in the ADSL2 specification:
L2 low power: Power consumption is reduced at the
local unit when there is no traffic. Entry to and exit from
L2 low power mode happens so quickly that it is
undetectable by the user.
L3 low power: The port enters sleep mode during
extended periods of inactivity, saving power at both the
local and remote units.
Power Management State
Enabling
Select the line states that the port may autonomously
switch to on this line:
Idle – L3 low-power mode
Low Power – L2 low power mode
Both – Both L2 and L3 low power modes
None – Power management is disabled
L0 Time
Specify the minimum number of seconds allowed between
an exit from the low power (L2) state and the next entry into
the low power state.
Field
Description
